|Visual Appearance||High Gloss|
|Solids by Weight||100 percentage|
|pH Range||2.5 – 14|
|Max. Dry Operating Temperature||275 F|
|Functional Cure||60 hours|
|Full Cure||120 hours|
|Pot Life at 70 F||45 min.|
|Equipment||Brush, Roller, Airless Spray|
|Number of Coats||2 – 3|
|Theoretical Coverage Per Gallon||40 mil. sq. ft.|
|Film Thickness Per Coat||10 mils min.|
25 mils max.
|Maximum DFT||75 mils|
|Recoat Time at 70 F||8 – 120 hours|
|Min. Application Temperature||40 F|
|Mixing Ratio by Weight||2.7:1 (B/A)|
|Mixing Ratio by Volume||2:1 (B/A)|
|Dry to Touch||10 hours|
|Force cures can be used to accelerate the cure or to enhance both physical and chemical properties. Force curing should not start until material has firmly set. Contact DUROMAR for specific instructions.|
|Storage||This product has a minimum shelf life of one year when stored in a dry area at 50 F – 100 F in the original sealed container.|
|Handling and Safety|
|Warning Eye and skin irritant. May cause dermatitis and sensitization.|
Always read and understand the product MSDS.
Avoid contact with eyes, skin or clothing. Avoid breathing vapor, mist or spray. Use with good ventilation.
|In case of contact:|
Eyes: Immediately flush with water for at least 15 minutes.
Skin: Immediately remove from skin with dry cloth followed by thorough washing with soap and water.
Inhalation: Remove to fresh air. If breathing is difficult, give oxygen.
Ingestion: Give large quantity of milk or water, induce vomiting. Contact a physician immediately.
1110 High Performance Lining
DUROMAR HPL-1110 is a flexible, low viscosity, easy to use industrial pipe coating system used on structural steel, tank exteriors or other areas where extra corrosion resistance is required. It is shipped DOT non-corrosive.
Multi-functional epoxy with a uniquely modified alkyl-amine.
We have other products and systems of which we can Engineer to fit your application. Give us a call at 801-977-0508!