|Inorganic Acids||Very Good|
|Organic Acids||Very Good|
|Flexural Strength at 70 F||>10000psi|
|Tensile Strength at 70 F||>10000psi|
|Tensile Adhesion at 70 F||>1800psi|
|Max. Dry Operating Temperature||500F|
|Operating pH Range||1.5 – 14.0|
|Packaging||10 kg kits|
5 kg kits
|2 parts base (B) to 1 part (A) hardener by volume|
3 parts Ceramic Beads to 1 part actives by weight
3 parts Ceramic Beads to 2 part actives by volume
5 parts base (B) to 2 part (A) hardener by weight
|Pot life for a unit mixed with sand is about 45 minutes at 70 F. Higher temperatures or larger volumes will shorten this time. Lower temperatures or spreading out the mix will extend the pot life.|
|Clean Up||All mixing and applications tools may be cleaned withMEKor other suitable solvent immediately after use.|
|Coverage||DURO-WEAR has the consistency of a heavy paste. Theoretical coverage at 1/2 inch is 0.3 ft/kg|
|Mixing & Application|
|Before mixing, make sure all surfaces are clean and dry.|
Use complete units to insure correct mix ratio. Place the Base (B) portion of the Kit into a suitably sized and clean mixing container. Add the Hardener (A) to the Base (B) and mix for about 30 seconds. Once mixed, add the ceramic beads to obtain the desired consistency. Blend until thoroughly wetted, about 1 to 2 minutes. For a dryer mix use more beads, for a more fluid mix use less beads. Material temperature should be between 70 F and 95 F and surface temperature at least 65 F.
|Vacuum, sweep, or otherwise remove all loose sand from the above surface. The resulting rough sand textured surface may be coated with a variety of topcoats, depending on the application and additional desired features.|
|Storage||Store in dry area in closed containers between 50 F and 110 F. Shelf life at these conditions is greater than one year.|
|Health and Safety|
|READ AND UNDERSTAND ALL MATERIAL GIVEN IN THE MSDS SHEETS BEFORE USING THE PRODUCT.|
DURO-WEAR DOES NOT CONTAIN ANY FLAMMABLE MATERIAL OF ANY KIND. HOWEVER, THE MATERIAL IS COMBUSTIBLE. IN THE EVENT OF A FIRE, DRY POWDER, FOAM, OR CARBON DIOXIDE FIRE EXTINGUISHERS SHOULD BE USED. FIRE FIGHTERS SHOULD WEAR RESPIRATORS.
USE PROTECTIVE GLOVES AND EYEGLASSES WHEN USING.
USE IN AREAS OF GOOD VENTILATION
|All recommendations covering the use of this product are based on past experience and laboratory findings. Methods or conditions of application and use of the product are beyond our control. We assume responsibility only for the uniformity of our product within normal manufacturing balances.|
DURO-WEAR Heavy Duty Wear Resistant Lining
DURO-WEAR is a specially formulated 100% solids epoxy lining, used for the protection and repair of areas subjected to severe abrasion and impact. Areas coated with DURO-WEAR are tough, abrasion and chemically resistant to a wide range of environments.
DURO-WEAR is dark grey in color. Other colors are available by special order.
We have other products and systems of which we can Engineer to fit your application. Give us a call at 801-977-0508!