1110 High Performance Lining

General Description
DUROMAR HPL-1110 is a flexible, low viscosity, easy to use coating system used on structural steel, tank exteriors or other areas where extra corrosion resistance is required. It is shipped DOT non-corrosive.

Chemical Description
Multi-functional epoxy with a uniquely modified alkyl-amine.

Components 2
Visual Appearance High Gloss
Density 1.25
Solids by Weight 100 percentage
pH Range 2.5 – 14
Inorganic Acids Good
Organic Acids Good
Alkalis Good
Solvents Fair
Hydrocarbons Good
Max. Dry Operating Temperature 275 F
Functional Cure 60 hours
Full Cure 120 hours
Repair System EAC
Surface Prep SSPC-6
Adhesion Excellent
Flexibility Excellent
Pot Life at 70 F 45 min.
Equipment Brush, Roller, Airless Spray
Number of Coats 2 – 3
Theoretical Coverage Per Gallon 40 mil. sq. ft.
Film Thickness Per Coat 10 mils min.
25 mils max.
Maximum DFT 75 mils
Recoat Time at 70 F 8 – 120 hours
Min. Application Temperature 40 F
Mixing Ratio by Weight 2.7:1 (B/A)
Mixing Ratio by Volume 2:1 (B/A)
Dry to Touch 10 hours
Force Curing
Force cures can be used to accelerate the cure or to enhance both physical and chemical properties. Force curing should not start until material has firmly set. Contact DUROMAR for specific instructions.
Storage This product has a minimum shelf life of one year when stored in a dry area at 50 F – 100 F in the original sealed container.
Handling and Safety
Warning Eye and skin irritant. May cause dermatitis and sensitization.

Always read and understand the product MSDS.

Avoid contact with eyes, skin or clothing. Avoid breathing vapor, mist or spray. Use with good ventilation.

First Aid
In case of contact:
Eyes: Immediately flush with water for at least 15 minutes.
Skin: Immediately remove from skin with dry cloth followed by thorough washing with soap and water.
Inhalation: Remove to fresh air. If breathing is difficult, give oxygen.
Ingestion: Give large quantity of milk or water, induce vomiting. Contact a physician immediately.

Request More Information