DURO-WEAR Heavy Duty Wear Resistant Lining

DURO-WEAR is a specially formulated 100% solids epoxy lining, used for the protection and repair of areas subjected to severe abrasion and impact. Areas coated with DURO-WEAR ore tough, abrasion and chemically resistant to a wide range of environments.

Colors
DURO-WEAR is dark grey in color. Other colors are available by special order.

Features
  • Good chemical resistance
  • Outstanding resistance to abrasion
  • Outstanding resistance to impact
  • Easy to apply
  • Self-Priming
Inorganic Acids Very Good
Organic Acids Very Good
Solvents Good
Alkalis Excellent
Salts Excellent
Alcohols Excellent
Hydrocarbons Excellent
Density 2.9
Solids 100 percentage
Flexural Strength at 70 F >10000psi
Tensile Strength at 70 F >10000psi
Tensile Adhesion at 70 F >1800psi
Max. Dry Operating Temperature 500F
Compressive Strength >12000psi
Operating pH Range 1.5 – 14.0
Packaging 10 kg kits
5 kg kits
Mixing Ratio
2 parts base (B) to 1 part (A) hardener by volume
3 parts Ceramic Beads to 1 part actives by weight
3 parts Ceramic Beads to 2 part actives by volume
5 parts base (B) to 2 part (A) hardener by weight
Pot Life
Pot life for a unit mixed with sand is about 45 minutes at 70 F. Higher temperatures or larger volumes will shorten this time. Lower temperatures or spreading out the mix will extend the pot life.
Color Dark Gray
Clean Up All mixing and applications tools may be cleaned withMEKor other suitable solvent immediately after use.
Coverage DURO-WEAR has the consistency of a heavy paste. Theoretical coverage at 1/2 inch is 0.3 ft/kg
Surface Preparation
  • For maximum adhesion, material should be applied to a firm, clean, dry and abraded surface.
  • Clean greasy, oily or waxed surfaces with suitable solvent before applying material.
  • Best results will be obtained by abrasive blasting or grinding to give a surface profile.
Mixing & Application
Before mixing, make sure all surfaces are clean and dry.
Use complete units to insure correct mix ratio. Place the Base (B) portion of the Kit into a suitably sized and clean mixing container. Add the Hardener (A) to the Base (B) and mix for about 30 seconds. Once mixed, add the ceramic beads to obtain the desired consistency. Blend until thoroughly wetted, about 1 to 2 minutes. For a dryer mix use more beads, for a more fluid mix use less beads. Material temperature should be between 70 F and 95 F and surface temperature at least 65 F.
Overcoating
Vacuum, sweep, or otherwise remove all loose sand from the above surface. The resulting rough sand textured surface may be coated with a variety of topcoats, depending on the application and additional desired features.
Storage Store in dry area in closed containers between 50 F and 110 F. Shelf life at these conditions is greater than one year.
Health and Safety
READ AND UNDERSTAND ALL MATERIAL GIVEN IN THE MSDS SHEETS BEFORE USING THE PRODUCT.

DURO-WEAR DOES NOT CONTAIN ANY FLAMMABLE MATERIAL OF ANY KIND. HOWEVER, THE MATERIAL IS COMBUSTIBLE. IN THE EVENT OF A FIRE, DRY POWDER, FOAM, OR CARBON DIOXIDE FIRE EXTINGUISHERS SHOULD BE USED. FIRE FIGHTERS SHOULD WEAR RESPIRATORS.

USE PROTECTIVE GLOVES AND EYEGLASSES WHEN USING.

USE IN AREAS OF GOOD VENTILATION

Limited Warranty
All recommendations covering the use of this product are based on past experience and laboratory findings. Methods or conditions of application and use of the product are beyond our control. We assume responsibility only for the uniformity of our product within normal manufacturing balances.

Request More Information